The following table shows the operation procedures of function setting under PELCO P/D, take CM6800 (matrix swKBD200
(keyboard) of PELCO for example.
KBD200
Enter 95 and then press “PRESET” key to access menu of the domes.
Access Menu of the Dome
Use the direction keys to position the cursor and select a parameter.
Enter the desired preset number, and then press “PRESET” key for 2
seconds to enter PRESET menu to set a preset.
Setting and Calling Presets
Enter the desired preset number, and then press “PRESET” key to call a preset.
Enter 1, and then press “PATTERN” key for 2 seconds. After “PATTERN” is
showed on the screen, use the keyboard to control dome cameras. Press “ACK”
key to end pattern setting.
Enter 1, and then press “PATTERN” key to call a pattern.
Setting and Calling Patterns
When a pattern is set, the screen display is provided according to CM6800
matrix switcher.
Enter 92
，
and then press “PRESET” key to define the start point of the
AUTOPAN.
Enter 93
，
and then press “PRESET” key to define the end point of the AUTOPAN.
Enter 98
，
and then press “PRESET” key to call the AUTOPAN.
Setting and Calling AUTOPAN
When AUTOPAN is set, the screen display is provided according to
CM6800 matrix switcher.
AUTOSCAN
Enter 99 and then press “PRESET” key to call the AUTOSCAN.
Area
Use programming menu of the super domes to set the areas.
180º Flip
Enter 33 and then press “PRESET” key to call the flip.
Home Position
Enter 34 and then press “PRESET” key to call the Home Position.
24
