Infinity DMC 1000, User Manual

Page: 150 / 150

150 DMC 1000 Digital Media Camcorder User’s Guide (v1.15)
Chapter 14 - Maintenance
14.4 Touch screen calibration
If the touch screen does not respond accurately to your taps you need to recalibrate the
screen. To do this follow these steps:
1. In the viewfinder menu, go to the
SYSTEM/PIN CODE/ENTER PIN
menu and enter “0000”
to set the user level to service level 1.
2. In the side panel menu, go to the
SYSTEM / SIDEPANEL
menu.
3. Tap the
CALIBRATION
button to start the touch screen calibration procedure.
4. Follow the instructions on the screen.
☞
Note
When the touch screen cannot be used due to misalignment, push and hold the Home push
button
on the side panel display for five seconds. The calibration settings will be reset to
their factory defaults. After resetting, perform the touch screen calibration procedure.
14.5 Cleaning the touch screen
☞
Note
Always turn off the camcorder before cleaning the touch screen.
Use a soft and dry cloth (preferably microfiber tissue) to clean the surface of the touch screen.
Wipe gently and do not apply strong pressure as this may damage the screen.
14.6 Troubleshooting
Symptom Cause Solution
No on-screen indicators or
information visible in the
viewfinder. Option (hide) switch on the
viewfinder is in the ON
position. Set the Option (hide) switch to the OFF
position.
Internal clock is reset to
00:00:00 after startup. Built-in battery is exhausted. Contact your Grass Valley service contact to
have the battery replaced.