P a g e
| 10
LT 7602 Issue No2 (07/17)
480 HD USERS INSTRUCTIONS
To Clean the Pilot assembly. Remove the two M4 nuts and glass clamp (See Fig 8). Carefully
lift the glass panel from within the bottom location. Remove the log and bark chip shapes.
Lift out the air tray assembly from within the burner shelf.
The pilot is located on the right hand side of the appliance, remove any debris in or around
the pilot head and the aeration hole. This can be achieved using the nozzle of a vacuum
cleaner. It is advisible not to blow the debris within the pilot head or aeration hole as this
may cause more of a restriction and not rectify the problem.
Note-Take care when cleaning in this area so as not to damage the pilot assembly.
Cleaning the fuel bed shapes. (Please refer to customer protection information on page 3 of
this booklet before cleaning or replacing any refractory materials).
The fuel bed components are delicate and they should be handled with great care. They
can be brushed very gently with a soft brush to remove dust or any deposits. A vacuum
cleaner may only be used after the loose components and moulded shapes have been
removed from the 480 HD fire box.
It is important that all fuel bed shapes are positioned as shown in these instructions.
Summary of Contents for 480HD
