Document Number: 002-10634 Rev. *J
Page
249 of 307
S6J3350 Series
Page
Section
Change Results
161
8.Precautions and
Handling Devices
8.1.1Precautions for
Product Design
Revised as below:
Error)
(1) Preventing Over-Voltage and Over-Current Conditions
Exposure to voltage or current levels in excess of maximum ratings at any pin is likely to cause
deterioration within the device, and in extreme cases leads to permanent damage of the device. Try
to prevent such overvoltage or over-current conditions at the design stage.
Correct)
(1) Preventing Over-Voltage and Over-Current Conditions
Exposure to voltage or current levels in excess of maximum ratings at any pin is likely to cause
deterioration within the device and in extreme cases leads to permanent damage of the device. Try
to prevent such overvoltage or over-current conditions at the design stage.
162
8.Precautions and
Handling Devices
8.1.2Precautions for
Package Mounting
Revised as below:
Error)
Surface Mount Type
Correct)
Surface Mount Type
165
9.Electric
Characteristics
9.1.1 Absolute
Maximum Rating
Deleted Remarks comment as below:
Error)
Supply voltage
Operation assurance range, DV
CC
, Remarks “DV
CC
≤V
CC
5”
Correct)
Power supply voltage, DV
CC
, Remarks “”
165
8.2Handling Devices Added Note of a function as below:
Method to Switch off VCC12 during Power-off Sequence
During power-off sequence, it is necessary to switch off VCC12 by driving PSC1 pin low by entering
PSS mode (power domain 2 off). If VCC12 needs to be switched off by other means, RSTX needs
to be asserted before switching off VCC12 to inactivate the operation of VCC12 supplied domain
below the operation assurance range.
165
166
9.Electric
Characteristics
9.1.1 Absolute
Maximum Rating
Added Note of a comment as below:
Maximum clamp current, Total maximum clamp current
Correct)
*13 VI or VO should never exceed the specified ratings. However, if the maximum current to/from an input is
limited by a suitable external resistor, the ICLAMP rating supersedes the VI rating.
167
9.Electric
Characteristics
9.1.1 Absolute
Maximum Rating
Revised Warning of a comment as below:
Error)
Note:
− Application of stress (e.g., voltage, current, temperature) exceeding the absolute maximum rating may cause
damage to the semiconductor device. Therefore, make sure that nothing exceeds the rating.
Correct)
WARNING:
− Semiconductor devices may be permanently damaged by application of stress (including, without limitation,
voltage, current or temperature) in excess of absolute maximum ratings. Do not exceed any of these ratings.
