BOOSTER
WITH LAP-SASH SEA
T BEL
T
SET UP
CONVERTING TO A BOOSTER SEAT
Figure 1
Disengage the buckle, undo the cover flap located
between the leg straps and place the buckle in the
recessed section of the plastic base. Close the flap in
the cover. Refer to arrow in Figure 1.
Disengage shoulder straps from spreader plate as
shown on page 14 & 26. (To change the shoulder slot
height, steps 1 to 5). Remove shoulder pads & buckle
pads and store in a safe place for keeping. Place the
shoulder straps behind the cover, thread through the
backrest shoulder slots and reconnect to the metal
spreader plate. Tightening the harness with harness
adjuster strap located at the front of the seat. Place
the two buckle tongues in the recess in the plastic
base at point (A) in Figure 3.
The harness is now behind the seat cover for storage
until needed as a car seat.
Step 1:
Step 2:
Figure 2
Figure 3
(A)
(A)
FOR USE OF THIS RESTRAINT AS A
BOOSTER SEAT THE HARNESS MUST BE
STORED BEHIND THE COVER. FOLLOWING
STEPS EXPLAIN HOW THIS IS TO BE DONE.
IMPORTANT
!
SELECTION OF APPROPRIATE PADDING COMBINATIONS
Determine whether your infant/child requires the additional padding provided with this restraint, to
ensure a safe and snug fit in the restraint. Refer to page 6 for suggested padding combinations.
Ensure the recline section is swung
rearward (see Figure 1).
At the front of the restraint is a red
lever. Pull red lever forward and slide
the seat to obtain the desired upright
or reclined angle.
RECLINED POSITION
- Refer to the shoulder height labels
(As shown on pages 31 & 32).
IMPORTANT
!
34
Summary of Contents for CS4210
Page 47: ...NOTES...
