Upper anchorage strap and attachment clip
must always be used
Upper Anchorage strap and attachment
clip must only be attached to the correct
anchor fitting
Always ensure that the upper attachment clip
is correctly engaged to the anchor fitting
This restraint is not suitable for use in a
hatchback or wagon where the anchorage
strap may fall into a split in the seat back
Straps may be damaged by unsecured cargo
in a collision. Secure or remove hazardous
cargo before using this restraint. Hatch-back
or wagon: Do not use the child restraint where
this strap may fall into a split in the seat back.
Always attach hook and remove slack.
FOR CARS FITTED WITH A CHILD RESTRAINT ANCHORAGE POINT
LOCATE THE ANCHORAGE POINT BEHIND THE REAR SEATING POSITION
CONSULT THE CAR OWNER’S HANDBOOK FOR LOCATION OF ANCHORAGE POINTS.
REMOVE THE THREAD PLUG FROM THE PARCEL SHELF/FLOOR/ROOF AND INSTALL THE ATTACHMENT
BOLT AS SHOWN IN FIGURE 1A & 1B.
UPPER ANCHORAGE FITTINGS
Attachment Bolt
Some vehicles may have an anchor fitting already
fitted by the vehicle manufacturer.
If no anchorage points can be found refer to
the vehicle manufacturer, or an authorised child
restraint fitting station for the best location of an
anchorage point.
Refer to the vehicle owners handbook or child
restraint fitting station for the possible use of
spacers.
Some vehicles may require the use of additional
extension straps (not supplied with this child
restraint)
If so ring InfaSecure on (Aust) (02) 4728 8080 for
nearest supply location.
CS111 300mm
CS112 600mm
CS113 200 - 900mm Adjustable
THIS RESTRAINT MUST BE ATTACHED TO A CHILD RESTRAINT ANCHORAGE POINT IN THE CAR.
CAUTION: DO NOT OVERTIGHTEN ATTACHMENT
BOLT. MAXIMUM TORQUE IS 20NM.
WARNING
!
3
Summary of Contents for CS4210
Page 47: ...NOTES...
