BOOSTER
WITH LAP-SASH SEA
T BEL
T
Ensure the restraint is set up in booster seat mode
(refer page 34).
Place the restraint in desired upright or reclined
position, with the back against the back of the vehicle
seat, directly in line with the anchorage point (refer
Figure 1).
Step 5:
Install the upper anchorage fitting as shown on page
3 & 4 of these instructions
Hook the attachment clip to the anchor fitting. Ensure
there are no twists in the upper anchorage strap
(Refer to Figure 2)
Pull to tighten to remove all the slack, from the upper
anchorage strap. Do not overtighten as this could
cause the restraint to lift off the vehicle seat (Refer to
Figure 2)
Always use upper anchorage strap to attach
the child restraint to the vehicle.
Do not use the restraint without the upper
anchorage strap correctly attached and
adjusted.
Do not use on any vehicle seat which faces
sideways or rearwards.
IF AN AIRBAG IS FITTED IN THE SEATING
POSITION WHERE THE CHILD RESTRAINT
IS TO BE FITTED, FOLLOW THE VEHICLE
MANUFACTURER’S WARNINGS AND
INSTRUCTIONS.
Fit the restraint firmly to the car seat.
WARNING
!
ADJUSTER
ATTACH
PULL TO
TIGHTEN
Tilt
Pull to
lengthen
Pull to
tighten
Figure 2
Figure 1
36
Summary of Contents for CS4210
Page 47: ...NOTES...
