CORRECT SHOULDER HEIGHT FOR REARWARD FACING MODE
The correct height for the shoulder straps is very
important for the optimum performance of the
restraint.
The shoulder slots used in rearward facing position are below the lower shoulder height
marker.
With the child correctly sitting in the restraint, check which set of slots (In the plastic shell
of the restraint) are level with or just above the infant’s shoulders.
If the harness straps are located in those slots, then the you can proceed with using the
restraint (see section “USE” on page 19). If not then adjust the shoulder straps.
Refer to “Shoulder Slot Height”.
IMPORTANT
!
The shoulder straps must be in the slots which
are nearest to the child’s shoulders, but not
lower than the child’s shoulders.
U
Figure 1
Front of vehicle
Refer to shoulder height marker (As shown on page 9)
For the correct shoulder strap slot height refer to page 14.
IMPORTANT
!
The headrest can be adjusted to different heights to
best suit your child. The headrest has a locking nut
on the rear of the restraint. This can be done with the
child in the seat.
Undo the adjustment nut which is located at the back
of the headrest, to move the headrest either up or
down.
Adjust the headrest height so that the bottom of the
sash guide is located level with or just above the
child’s shoulder.
Once the headrest is in the correct position tighten
the adjustment nut and check the headrest is locked
into place.
INF
ANT
WITH INBUIL
T HARNESS
INSTALLATION
13
Summary of Contents for CS4210
Page 47: ...NOTES...
