Indian Motorcycle Chief Dark Horse 2020, Owner'S Manual

Page: 135 / 194

HHAANNDDLLEEBBAARR PPOOSSIITTIIOONN
On models equipped with two handlebar positions, the motorcycle
is manufactured with handlebars in the low position. Before
changing handlebar position, check regulations in your area of
operation. Operation with the handlebars in the high position may
not be legal in all areas for all riders.
WARNING
Handlebar control position must be checked for proper
alignment each time handlebar position is changed. Failure to
reposition controls could result in loss of vehicle control resulting
in severe injury or death.
To change the handlebar position, do the following:
CAUTION
Protect painted surfaces on the front fender and fuel tank prior to
beginning the following procedure. Use care when removing the
nacelle so the chrome does not get scratched.
CAUTION
During disassembly, pay close attention to harness routing and
connector orientation. Always route electrical wiring the same
way as it was removed to avoid damaging wires and connectors.
1. Remove windshield assembly, if equipped.
2. Remove two fasteners
q
at the top of the nacelle assembly.
3. Remove two fasteners
w
securing the console cover to the fuel
tank and lift console back and set on protected fuel tank.
4. Remove two fasteners per side securing the windshield
mounting bracket assembly.
5. Rotate the auxiliary lamp assembly forward and lower out of the
way.
6. Pull the rear portion of the nacelle assembly back toward the
fuel tank to expose the handlebar risers.
133
MAINTENANCE
https://www.motorcycle-manual.com/