3
Model Disassembly instructions
© 2011 Enter your company name
1.3.1
Clear major paper jam
•
Remove the front glass - see instruction
•
Cut the paper above and below the embossing head with a sharp thin knife (switch blade knife).
Avoid the rubber rollers.
•
Remove and clear the the embossing head from jammed paper
•
Rotate the rollers for checking and removing jammed paper
•
Remove embossing head - see instructions
•
Clean the embossing head from jammed paper
1.3.2
Remove front glass
•
Remove the 2 knurled thumb screws from the glass
•
Press the glass down
•
Remove the glass by lifting it up
1.3.3
Remove back plate
•
Remove the four screws holding the back plate (picture with four screws)
•
Lift up the back plate by twisting a flat screw driver between the lower center of the plate and
aluminum profile
•
Lift up the back plate carefully
1.3.4
Remove side covers
•
Remove the front glass
•
Remove the back plate
•
Remove the side covers
- 8 screws on left side cover (top front = smaller 3.5x13)
- 7 screws on right side cover
1.3.5
Replace sheet feeder
•
Remove the two screws on the top of the sheet feeder
•
Lift up the sheet feeder
•
Disconnect the sheet feeder cable
1.3.6
Replace main board
•
Remove back plate - see instruction
•
Release the main board from the 4 upper click connectors
•
Remove all cable from the main board
•
Tilt the main board to a 45 degrees angle
•
Lift the main board towards you.
•
Remove the SD memory card from the faulty main board.
The Index SD memory card includes embosser specific parameters as for example: serial
number, number of embossed pages, page format, embosser settings.
When inserting a new main board please Insert the original SD memory card before powering on
the unit.
