2
V4 Service manual
© 2011 Enter your company name
•
Remove the SD memory card from the faulty main board.
The Index SD memory card includes embosser specific parameters like serial number, number
of embossed pages, page format, embosser settings, etc.
Insert Main Board
•
Insert the original SD memory card from the previous main board to the new main board
•
Place the new main board in position and make sure it clips in OK
•
Connect all cables (see picture)
•
Insert embossing head - see instruction
•
Connect main board cable
•
Insert back plate - see instruction
1.2.5
Replace Paper Tractors
•
Remove the back plate - see instruction
•
Remove the embossing head - see instruction
•
Remove motor side cover - see instruction
•
Remove the 3 screws holding locking ring for the tractor feed square axle and remove the axle
•
Remove the round axle ( flat screw driver) by turning it CCW Contra Clock Wise.
•
Disconnect the two paper sensors
•
Remove the formula tractors
(PHOTO Position of square axle - dots on the tractor)
When inserting new formula tractors, please note the position of the small dots near the hole for
the square axle. These marks has to be on the same side of the square axle.
1.2.6
Replace motor module
•
Remove the back plate - see instructions
•
Remove the embossing head - see instructions
•
Remove the side cover - see instructions
•
Disconnect 2 motor cables
•
Unscrew the 6 screws holding the motor module
•
Remove the motor module
1.2.7
Remove the fan
•
Remove the back plate - see instruction.
•
Remove the embossing head - see instruction
•
Remove side cover - see instructions
•
Disconnect the 4 screws holding the fan from the motor module
•
Remove the fan
1.3
Everest-D
Enter topic text here.