7
Model Disassembly instructions
© 2011 Enter your company name
1.4.3.2.3 Replace embossing head
REMOVE EMBOSSING HEAD
•
Open the service door - see
•
Remove the Embossing head locking ring (picture)
•
Release the embossing head axle by pressing it against you (picture)
•
Disconnect the embossing head cable
INSERT EMBOSSING HEAD
1. Open the Braille out tray
2. Insert the embossing head axle in the embossing head
3. Insert the embossing head locking ring on the embossing head axle (Bild)
4. Connect the embossing head cable please note the direction (picture)
5. Press the plastic sprig up, to give room for the print head profile with gear bar during step 6-8
(Bild)
6. Insert the embossing head in the position between the stepper motor gear wheel (p
video)
7. Insert the right side of the embossing head axle in the holder
8. Insert the left side of the embossing head axle in the holder by pressing it against the embosser
until it click in position
9. Press the embossing head locking ring to the left against the holder
10.Move the embossing head by hand to check the mechanical movement
11.Close Braille out tray
12.Close the service door
1.4.3.2.4 Replace roller module
•
Open the Service door - see instructions
•
Remove the paper movement driving belt from gear belt wheel on the selected roller axle
•
Remove the 4 screws holding the axle bearing
•
Take out the roller module
1.4.3.2.5 Replace paper out flip flop
Remove
•
Remove Braille tray - see
•
Disconnect the cables for both DC motors
•
Unscrew the two screws holding the front flip flop motor module and remove the motor module
and arm
•
Unscrew the two screws holding the back flip flop motor module and remove the motor module
and arm
Insert
•
Insert the back flip flop arm horizontally, place the motor module in position and tighten the two
screws
•
Insert the front flip flop arm horizontally, place the motor module in position and tighten the two
screws
•
Connect the two cables to the flip flop motors
1.4.3.2.6 Replace ventilation module
•
Open the Braille out tray
•
Disconnect the 2 fan cables
•
Unscrew 4 screws in the technical corner from the outside
•
Unscrew 4 screws holding the ventilation module against the outer plate