Can I put the chair onto an electric carpet?
Do not place the chair onto an electric carpet
because it could cause a fire.
The chair is very heavy, so it could damage the heat
generating parts of the electric carpet and start a
fire.
→
See P7
Can I put the chair onto a wooden floor or a heated
floor?
Yes.
However, because the chair could damage the
floor surface, we recommend laying a carpet or
something similar under the chair. (Same applies to
other floor surfaces)
→
See P7
How do I make the massage deeper?
Perform the following:
●
Sit back further in the chair so that your weight is
against the reclining seat back.
●
Lower the reclining seat back.
→
See P13
●
Remove the buffer pad from behind the back
pad.
(When installed)
→
See P10
With the methods above, you can intensify the massage.
How do I make the massage lighter?
Perform the following:
●
Raise the reclining seat back.
→
See P13
●
Insert the thin or thick buffer pad into the rear of
the back pad.
→
See P10
●
Remove the shiatsu pad and shiatsu sheet.
(When installed)
→
See P11
With the methods above, you can make the massage more
gentle.
Can I use both buffer pads at the
same time?
Do not use both pads at the same time.
Using both buffer pads at the same time may injure
your body.
Does the reclining seat back move automatically
during a massage or after a program has finished?
The reclining seat back does not move
automatically after a program has finished.
However, depending on the selected program, the
reclining seat back may move automatically while a
program is in progress.
Can someone who is under 150 cm or over 180 cm
use the chair?
Yes.
Because the correct shoulder positions may not be
found during shiatsu point locating, we recommend
using the chair as follows.
●
Short person: Raise the reclining seat back
→
See P13
●
Tall person: Recline the reclining seat back
→
See P13
●
After shiatsu point locating is performed, adjust the
shoulder positions.
→
See P18
The remote control panel has come off. Can I fix it?
Reattach with the following method.
Hold the remote control as illustrated, and
reattach by inserting the projection on the bottom
of the panel into the hole on the remote control.
*You may damage the remote control panel if you open it too
much. If you damage the panel, contact the vendor.
I spilled water on the chair. What should I do?
There is a danger of an electric shock. Immediately
stop using the chair and perform the following.
●
Set the main POWER switch located at the front
right of the chair to OFF.
●
Unplug the power plug from the wall outlet.
After performing the above, contact the vendor for
assistance.
FAQ
21
[F
A
Q
]
