33
2. Touch the visualisation to adjust the desired level.
3. Or enter a number in the [required vacuum] field.
4. Press [start vacuum control] to start the pump and let ECOMIZER-PRO control the water level
to your preferences.
1.
Check “Use level sensor” if you have connected and installed the hydrostatic pressure sensor.
2. Enter the Sensor depth relative to the ground surface. Every red mark on the sensor cable is
1 meter.
3.
Press [Start vacuum control] to start the pump on vacuum control
If any fields are filled in incorrectly, one of the following
errors will occur:
1.
Sensor depth too low
: The current level the
sensors measures exceeds the sensor depth.
- Adjust the sensor depth to a higher value.
2.
Set desired level
: Required level exceeds the
sensor depth.
- Adjust the required level to a smaller value than
the sensor depth.
- Adjust the sensor depth to a higher value than
the required depth
Summary of Contents for Yamuna
