PAGE 17
c:
Apply silicone sealant down the inside of the ‘long and short sides’ of the
corner joints.
d:
Push fit the corner joint caps on to the corner joints.
e:
Carefully
push the ‘short side’ of the corner joints fully onto the main panel.
A:
Aluminium threshold strip
- Position the strip
up against
the corner joints.
Run a bead of silicone sealant down the length of the threshold strips. Carefully push the
return panels (the correct way around) into the corner joints (
1
). Slide the return panels
down the corner joints and into the threshold strips (
2
). Wipe off any excess silicone.
B:
Plastic threshold strip
- Position the strips onto the bottom of the return panels,
flush with the edge (
1
). Carefully push the panels (the correct way around) into the
corner joints (
2
) and ensure the strips make full contact with the floor.
Options C & D -
continued
a
Option a:
Drilling floor for feet
- Use the dimensions above to mark and drill the ‘pin’ holes in the
floor. Using a 4mm drill bit, carefully drill shallow holes (no deeper than half the thickness of the tile
etc.). Use the allen key to adjust the ‘pin’ in the inner feet
*
to fit into the hole. Position the assembled
feet in the marked position.
Option b:
Sealing feet to floor
- Use the allen key to remove the ‘pins’ from the inner feet
*
. Apply
silicone sealant to the underside of the inner feet. Position each assembled foot in the marked position.
b
17
mm
17
mm
8
mm
ø 4
mm
*
2mm
2mm
*
2
1
Inside
11
Apply silicone sealant along the bottom of the panels and
optional feet
, as shown.
Without threshold strip
- from outside only, seal along the bottom of the panels and the corner joints also 50mm up the joints between the corner joints and panels.
Aluminium threshold strip
- from inside and outside, seal along the bottom and top of the threshold strips. From outside only, seal along the bottom of the corner joints. Also seal up the joints between the
corner joints and threshold strips.
Plastic threshold strip
- from outside only, seal along the bottom of the corner joints and up the joints between the corner joints and threshold strips.
Outside -
Aluminium threshold strip
Outside -
Plastic threshold strip
Outside -
Without threshold strip
Outside of foot
Inside of foot
Options C & D -
continued
From inside, if required adjust the height of the feet (
1
) so that
the return panels are vertical.
Tighten the grub screw (
2
) onto the return panels.
Push fit the screw cover caps.
3mm
MAIN
PANEL
(outside)
c
d
e
2
1
A
B
1
2
Sealant
A
