PAGE 9
OPTION 4 -
SINGLE PANEL WITH RETURN PANEL
3
2
Slide both seals down into the wall channel and
cut off any excess.
Note
the orientation of the soft flippers.
1
Place the wall channel in position against the wall at the required distance from the opposite
wall, as shown (a maximum of 1180mm).
a:
Ensure the wall channel is vertical and mark the four holes onto the wall.
b:
Drill the four positions marked using a 6mm drill bit.
c:
Apply silicone sealant to the back of the wall channel.
d:
Insert the wall plugs. Place washers over the 32mm screws and fix the wall channel to the
wall. If necessary, slight adjustment is available in the wall channel.
Carefully
push the panel (the correct way around) into
the wall channel.
Note:
Wetting the edge of the panel with water will
help the panel insert.
If not using the threshold strips,
proceed straight to step 7.
ø 6
mm
a
b
d
32
mm
1180mm
max.
c
IMPORTANT
Ensure Glass Guard
H2o label is to the
outside of the panel.
Satin glass patterns
MUST be installed
to the outside of the
panel.
Note:
The Glass
Guard coating is on
the opposite side to
the label or satin glass
patterns.
Tie bar
PN10786
Wall channel
PN10754
Corner joint PN11011
5
4
If using the threshold strip/s, there are 2 types
available (
A
&
B
) and 2 fitting options:
Option 1:
Fitting up to wall channel - follow
step 5.
Option 2:
Fitting inside wall channel - follow
step 6.
Optional threshold strips
A
Aluminium
B
Plastic
2
1
a:
Temporarily,
position the corner joint (short side
*
as shown) onto the main panel.
b:
Carefully
measure the panel between the wall channel and corner joint =
‘X’.
c:
Carefully trim your chosen threshold strip to length
‘X’
.
Remove the corner joint and panel from the wall channel.
Option 1 -
Fitting threshold strips up to the wall channel
A:
Aluminium threshold strip
- Position the strip
up against
the wall channel.
Run a bead of silicone sealant down the length of the threshold strip. Angle the panel and carefully push (the correct way
around) into the wall channel and threshold strip. Wipe off any excess silicone.
B:
Plastic threshold strip
- Position the strip onto the bottom of the panel, flush with the front (
1
). Carefully push the panel
(the correct way around) into the wall channel (
2
) and ensure the strip makes full contact with the floor.
A
B
X
X
a
b
c
*
Sealant
A
