PAGE 12
13
Option B -
Return panel with threshold strips
a
b
a:
Temporarily,
position the return panel into the ‘long side
*
’ of the corner joint.
(Ensure ‘Glass Guard H2o’ label is to the outside of the panel.)
b:
Position the ‘short side’ of the corner joint onto the main panel.
c:
Carefully
measure the length of return panel protruding out of the corner
joint =
‘X’.
d:
Carefully trim your chosen threshold strip to length
‘X’
.
Remove the corner joint and return panel.
X
c
d
MAIN
PANEL
(outside)
e:
Apply silicone sealant down the inside of the ‘long and short sides’ of the corner joint.
f:
Push fit the corner joint cap on to the corner joint.
g:
Carefully
push the ‘short side’ of the corner joint fully onto the main panel.
e
f
g
14
Option C -
Return panel with threshold strips and foot
&
Option D -
Return panel with foot only
c
a:
Temporarily,
position the return panel into the ‘long side
*
’
of the corner joint. (Ensure ‘Glass Guard H2o’ label is to the
outside of the panel.)
b:
Position the ‘short leg’ of the corner joint onto the main
panel.
c:
Use the 3mm allen key to wind-up the pin on the inner foot
*
so it is
flush with the underside. Place the inner foot into
the foot.
Position the assembled foot under the return panel, flush with the edge.
d:
Ensure the return panel is vertical and if required adjust the foot to level the panel. Mark the position of the foot onto
the floor (all the way around).
Carefully
measure the return panel between the corner joint and foot =
‘X’.
e:
Carefully trim your chosen threshold strip to length
‘X’
.
Remove the corner joint, return panel and foot.
*
*
a
b
X
d
X
e
X
*
RETURN
PANEL
(outside)
RETURN
PANEL
(outside)
RETURN
PANEL
(outside)
RETURN
PANEL
(outside)
RETURN
PANEL
(outside)
Option B -
continued
A:
Aluminium threshold strip
- Position the strip up against the corner joint. Run
a bead of silicone sealant down the length of the threshold strip. Carefully push the
return panel (the correct way around) into the corner joint (
1
). Slide the return panel
down the corner joint and into the threshold strip (
2
). Wipe off any excess silicone.
B:
Plastic threshold strip
- Position the strip onto the bottom of the return panel,
flush with the front (
1
). Carefully push the return panel (the correct way around) into
the corner joint (
2
) and ensure the strip makes full contact with the floor.
Now proceed straight to step 15 to seal the enclosure.
1
2
2
1
A
B
Sealant
A
3mm
