PAGE 11
9
ø 6
mm
f
e
PN80499
Remove the tie bar assembly from the panel.
a:
Unscrew the wall bracket from the end of the tie bar bracket.
b:
Place the wall bracket in the marked position and mark the fixing hole onto the wall.
c:
Drill the position marked using a 6mm drill bit, 30mm deep.
d:
Insert the wall plug and fix the wall bracket to the wall using a 32mm screw and washer.
Note:
The screws and wall plugs supplied are for masonry walls. For lightweight walls i.e. stud
partitions, plasterboard etc, use the correct type of fixings.
e:
Screw the tie bar bracket back onto the wall bracket.
f:
Reposition the tie bar into the tie bar bracket and the other end (with top panel bracket fitted) onto the
panel (with grub screw on the inside). Tighten the tie bar bracket grub screw onto the tie bar.
g:
From inside, tighten the grub screw (
1
) onto the panel.
Ensure the panel is vertical and tighten the grub
screw in the top of the bracket onto the tie bar (
2
). Push fit the screw cover cap.
10
Push fit the top cap onto the top of the wall channel.
32
mm
a
1
2
c
d
g
Inside
b
11
Return panel -
fitting options
Option A:
Without threshold strips and foot - follow
step 12.
Option B:
With threshold strips - follow
step 13.
Option C:
With threshold strips and foot - follow
step 14.
Option D:
With foot only - follow
step 14 (ignoring the threshold strips).
Option A -
Return panel without threshold strips and foot
MAIN
PANEL
(outside)
12
a:
Apply silicone sealant down the inside of the ‘long and short sides’ of the corner joint.
b:
Push fit the corner joint cap on to the corner joint.
c:
Carefully
push the ‘long side’ of the corner joint fully onto the return panel. (Ensure ‘Glass Guard H2o’ label
is to the outside of the panel.)
RETURN
PANEL
(inside)
a
b
c
d:
Carefully
push the corner joint and return panel fully onto the main
panel.
Now proceed straight to step 15 to seal the panel/s.
d
RETURN
PANEL
(outside)
A
B
C
D
3mm
2mm
