This shows the present state of discharge. To stop discharging press
Batt type/Stop
key once.
VOLTAGE BALANCING AND MONITORING DURING THE DISCHARGE
The processor monitors the voltage of individual cells during “storage-mode” and “discharge” of Lithium
battery pack. It tries to normalize the voltages to be equal. For this feature, the individual plug of the
battery pack should be connected to the individual port of the charger.
If the voltage of any one or more cells varies abnormally during the procedure, it terminates the process
forcibly with the error message. If this happens, the battery pack contains the bad cell, or the bad
connection of the cable or plug. You can easily know which one cell is bad by pressing
INC
button at time
of showing the error message.
The processor found that the voltage of one of the cell in the Lithium battery pack
is too low.
In this case, the 4th cell is bad. If there happens the connection-break of the cable
or plug, the voltage value may show zero.
NIMH/NICD BATTERY PROGRAM
These programs are for charging or discharging NiMH (Nickel-Metal-Hydride) or NiCd (Nickel-Cadmium)
battery commonly used for R/C models applications. To alter the value at the display, press
Enter
key to
make it blink then change the value using
INC or DEC
key. The value will be stored by pressing
Enter
key
once.
To start the process, press
Enter
button for more than 3 seconds.
CHARGING NICD/NIMH BATTERY
This program simply charges the battery using the current you set. In “Aut” mode,
you need to set the upper limit of charge current to avoid from higher feeding current
that may damage the battery. Because some batteries of low impedance and small
capacity can lead to the higher charge current by the processor at automatic charge
mode. But in “Man” mode, it will charge the battery with the charge current you
set at the display. Each mode can be switched by pressing INC and
DEC
button
simultaneously when the current field is blinking.
The screen displays the current state of charging. To stop the process, press
Batt
type/Stop
key once.
The audible sound indicates charge you the end of process.
DISCHARGING NICD/NIMH BATTERY
Set discharge current on the left and final voltage on the right. The discharge
current ranges from 0.1 to 2.0A and the final voltage ranges from 0.1 to 16.0V. To
start the process, press
Enter
key for more than 3 seconds.
The screen displays the current state of discharge. You can alter the discharge
current by pressing
Enter
key during the process. Once you change the current
value, store it by pressing
Enter
button again.
To stop discharging press
Batt type/Stop
key once.
The audible sound indicates you at the end of process.
C1: 3.71 C2: 3.72V
C3: 2.56 C4: 0.00V
NiMH[0] CHARGE A
CUR LIMIT 6.0A
NiMH[0] CHARGE A
CUR LIMIT 6.0A
ENGLISH
11
FRAN
Ç
AIS