CHARGING LITHIUM BATTERY
The left side of the first line shows the type of battery you select at the users setting. The
value on the left side of second line sets a charge current and the value on the right side of
second line sets the voltage of the battery
After setting the current and voltage press
Enter
key for more than 3 seconds to
start the process.
(Charge current: 0.1 - 6.0A, Voltage: 2 - 4 S)
This shows the number of cells you set up and the processor detects. “R:” shows
the number of cells found by the charger and “S:” is the number of cells selected by
you at the previous screen. If both numbers are identical you can start charging by
pressing
Enter
button. If not, press
Batt type/Stop
button to go back to previous
screen. Then carefully check the number of cells of the battery pack to charge again.
The screen shows the present situation during charge process. To stop charging
press
Batt type/Stop
key once.
It will show the voltage of each cell after pressing
INC
.
It can show 8 groups data for Max.
"Fuel": the percentage of the capacity
"Cell": the average single voltage
CHARGING LITHIUM BATTERY AT BALANCE MODE
This is for balancing the voltages of Lithium batteries of the battery pack to be charged. To do this, the
battery pack being charged should have the individual cell connector. And connect it to the individual port
at the right side of charger with a suitable connection cable that fits with your battery pack. And also, you
need to connect the battery output plug to the output of charger.
In this mode, the charging process will be different from ordinary charging mode. The internal processor
of the charger will monitor the voltages of each cell of the battery pack and controls the charging current
that is feeding to each cell to normalize the voltage.
The value on the left side of second line sets a charge current and the value on the right side
of second line sets the voltage of the battery pack.
After setting the current and voltage press
Enter
key for more than 3 seconds to
start the process (Charge current: 0.1-6.0A, Voltage: 2-4S).
This shows the number of cells you set up and the processor detects. “R:” shows the number of cells found
by the charger and “S:” is the number of cells “S:” is the number of cells selected by you at the previous
LiPo[0] CHARGE
2.0A 11.1V(3S)
LiPo[0] Balance
2.0A 11.1V(3S)
ENGLISH
9
FRAN
Ç
AIS
