The beep sounds at every time pressing the buttons to confirm your action. The
beep or melody sounded at various times during operation to alert different mode
changes. These audible sounds can be on or off.
Press
Enter
for 3 seconds to restore factory setting (default).
The Input voltage is 10-18V. This program monitors the input votlage of the battery.
If the voltage is lower than the setting value, then the operation will be stopped
forcedly to protect the input voltage.
This program aims to indicate the current software version number and hardware
ID number.
MEMORY MODE
The charger can save setting data of each program, it can save 10 groups data for each kind of battery,
including the cells of the battery, setting charge current and so on. Users do not need to set the data again
when they use batteries which have been memorized. It is easier and more convenient.
Choose the program of the corresponding battery type, press
INC or DEC
to choose any number from 0
to 9. Press
Enter
to enter the window of setting data. Users can enter to charge or back from current
window after finish the setting, then it do not set any data when you use the battery next time. Of course
users can re-set the new data if they want to change.
LITHIUM BATTERY (Li-Ion/Li-Po/Li-Fe/Li-Hv) PROGRAM
These programs are only suitable for charging and discharging Lithium batteries with a nominal voltage of
3.3V, 3.6V, 3.7V and 3.8V per cell. These batteries need to adopt different charge technique is termed
a constant voltage (CV) and constant current (CC) method. The charge current varies according to the
battery capacity and performance. The final voltage of charge process is also very important; it should be
precisely matched with the charade voltage of the battery. They are 4.2V for Li-Po, 4.1V for Li-Ion, 3.6V
for Li-Fe, and 4.35V for Li-Hv. The charge current and nominal voltage as for cell count set on the charge
program must always be correct for the battery to be charged.
When you are willing to alter the parameter value in the program, press
Enter
key to make it blink then
change the value with
INC or DEC
key. The value will be stored by pressing
Enter
key once.
ALARM: The Li-Hv mode just supports 4.35V Li-Hv battery, it is forbidden to use it for another kind of
battery. It cannot charge the Li-Po battery which voltage is 4.2V. Otherwise it will lead to explosion.
Load Factory Set
Enter
Product Version
V2.1.5 EADB8902
ENGLISH
8
FRAN
Ç
AIS