To switch to a PPM output, switch to the
Servo Mapping
tab of the Rx setup, and change the
CH1
servo output to
PPM Muxed
.
Bind the receiver to the transmitter, either using the button on the Rx, or the ImmersionRC tools,
Bind/RSSI
tab of the Rx setup page.
When correctly bound, the LED on the Rx should be ‘breathing’, indicating normal operation.
The only cable hookup to the EzUHF should be a single servo cable, between connector X2 on
the NAZA, and CH1 of the EzUHF receiver.
2) Setting up the Naza
Naza gain settings depend heavily upon the configuration of the XuGong.
Default settings are generally a good place to start from, and then fine tuning can be performed
following one of the multiple guides available with a quick google search.
Note that it is extremely important to correctly setup the position of the GPS vs. the center of
gravity of the Quad. The values below should be used.
