Note: This image shows some custom 3dprinted ESC housings. We will be publishing these
designs shortly!
Mounting the GPS/Compass
Holes in the top plate are provided for the standard DJI GPS/Compass. Even though it is
tempting to stick the GPS directly onto the back of the upper plate of the frame, it is highly
recommended to use the standard DJI ‘stalk’ supplied with the GPS.
Mount them with the nuts on the exterior part and the screw head in the inside, otherwise the
battery won’t fit in the compartment (and more seriously, the end of the screw shafts will tear the
battery housing, and potentially cause a fire).
The recommended height of the GPS above the top of the props is approx. 10mm. This requires
trimming 10mm from the standard GPS Carbon Fibre ‘stalk’.
Prop Installation
Props should be installed as shown in the picture below. The motor direction will be determined
later once the Naza is fired up for the first time
