Step 2: The Frame
a) Silicone Feet installation
First step in building the frame is to install the rubber feet. Don’t leave this until the end, since
they are difficult to install once the frame is assembled.
Lay out the bottom frame plate as shown below, and tease the feet into place.
NOTE: The ‘Hook’ as it has been described, in the topleft of the photo here is for mounting the
5.8GHz SpiroNet Antenna. A small piece of 3M VHB tape holds the antenna securely on the
bottom of the Quad.
b) Anti-Jello Damper installation
The antijello dampers should be installed next, as shown below. Again, don’t leave these until
later in the installation procedure, since they are difficult to install later.
