5
●
Note that the power cord should never touch any heat sources or sharp edges. Never let the
power cord dangle over the counter edge.
●
Stop using the appliance immediately if malfunctions of the unit occur. Unplug the appliance.
●
Do not use any accessory or spare parts that have not been recommended or designated by
the manufacturer. This can pose a danger for the user or lead to damages of the appliance or
personal injury.
●
Do not lay the power cord over carpets or heat insulations. Do not cover it with any other
objects. Keep away the power cord from operating range and do not immerse it into water.
●
Never touch the power cord, plug or the switch when your hands are wet.
●
Do not leave the unit unattended during operation.
●
Never move or reposition the unit when it is in operation.
●
WARNING! Hazard via electrical current! Make sure that the voltage of local power supply
matches that of the naming plate.
5.2 Installation and connection
ATTENTION!
The installation of the unit must be performed by a qualified technician only. Place the device on
top of a solid, even, safe and stable surface that tolerates the weight. Level it back and forth.
Then leave it side to side.
Not at any time should you place the appliance on top of an inflammable surface (such as: table
cloth, carpet, etc.).
You must not locate the appliance near open fireplaces, electric ovens, electric heaters or other
heat sources.
Position the device appropriately so that the plug is always accessible.
Make sure liquids enter neither the electrical system nor the switch. Dry off the device
thoroughly!
When you receive the product, the glass is packed separately inside the chamber. Unpack the
packages outside.
Assemble the shelving system and fit the front and rear sliding doors as indicated below:
G
lass sliding Doors
The unit has front and rear sliding doors. When unpacking, note that the longer doors fit at the
front / slopped section. The doors are fitted by placing the door into the channel in the top section
of the unit first, pushing the glass far enough up to enable the bottom of the door to clear the
bottom channel and drop down into position in the corresponding bottom channel. There are two
channels which allow the glass doors to slide past one another. Ensure that the handles are
toward the outside of the unit.
