SEL-1FS1/SEL-2FS1 and SEL-1XD1/SEL-2XD1
Installation and Operation Manual
Installation, Operation, and Specifications
© 2015 Imagine Communications Corp.
Proprietary and Confidential.
Version 2.8 | Page 73
Proc Ch 1 and 2 Out Format
Use these controls to select the output video format for processing channel outputs. The
Proc Bypass
option bypasses the scalar and all processing (noise reduction, detail enhancement, color correction,
etc.) but is downstream of the frame synchronization. The default is
Follow Ref
.
The SEL-1XD1 and SEL-1FS1 have one processing channel. The SEL-2XD1 and SEL-2FS1 have two
independent processing channels. All outputs can select the output of one processing channel. The
following outputs are available:
•
Four main board outputs
•
One output to primary and secondary controller modules
All outputs carry the converted program signal (XD1) or a frame sync signal (XD1 and FS1). The
converted program signal carries embedded audio, VANC data (WSS/VI/AFD) and CC/TT, Brandnet, and
timecode. Conversion is automatic, based on your selected output video standard.
Note:
If the output is SD-SDI, AFD and VI cannot be embedded into the same line.
Output Frame Rate (XD1)
The SEL-1XD1 and SEL-2XD1 provide basic automatic frame rate conversion (FRC). (A higher quality
linear frame rate converter is also available, with the SELOPT-SK-SC license key option. See Linear Frame
Rate Conversion (XD1) (on page 76).
Using the basic automatic FRC, audio/video alignment is variable ±1 frame. There must be a valid
reference available for the selected output standard, and you must set the
Output Frame Rate
in
Output Format and Mode
. If the input signal has a different frame rate from the output frame rate, the
FRC is enabled automatically. In this mode, two independent channels are operating at the same time.
One or both of the channels can be used for frame rate conversion.
Output Routing
These controls assign the SDI outputs to their processing channels.
Note
: EXT Video inputs and outputs can be disabled by the
Green-Power Save
control (
Misc > Green-
Power Save
). If an external video control is grayed out in the user interface, check its power save status.
Operation Mode
The following topics are included in this section:
•
Dual Channel Operation (on page
74
)
•
Live I-Wings Mode (on page 74)
•
Converter Fast Switch (XD1) (on page 75)
•
3D Modes (on page 76)
