SEL-1FS1/SEL-2FS1 and SEL-1XD1/SEL-2XD1
Installation and Operation Manual
Installation, Operation, and Specifications
© 2015 Imagine Communications Corp.
Proprietary and Confidential.
Version 2.8 | Page 32
5.
Open the front panel and then slide the correct front modules into the slots that match the back
modules.
6.
Push the module until it seats properly, ensuring the edge of the module is flush with the edge of
the module guides, and the square extractor handle clicks into its slot.
7.
Install the remaining back and front modules, make all of the necessary rear connections, and then
close the front panel.
CAUTION:
To prevent overheating during frame operation, keep the front panel closed and all back module
slots covered.
Removing the Front Module
To remove a front module from a Selenio frame, follow this procedure:
1.
Open the front panel.
2.
Grasp the extractor handle on the module, pulling down slightly.
3.
Using the handle, slide the module out of its slot.
Figure 22:
Removing a Front Module
4.
Close the front panel to ensure proper frame ventilation.
Removing the Back Module
To remove a back module from a video conversion module frame, unscrew the module, and then pull it
straight out. Then re-attach a blank back module to ensure proper frame ventilation.