26
DA-DHR/DH/DSR/DS/HR/H6802
+
Installation and Operation Manual
Preliminary—Contents are proprietary and confidential. Do not photocopy or distribute.
Chapter 3: Operation
Changing Parameter Settings
You can change module parameter settings locally with the card-edge
jumper or remotely by selecting the Reclocking Mode parameter
setting.
Changing Parameters Using CCS Software
Before using CCS software applications to change your module’s
parameter settings, you must refresh (
+
Pilot Lite) or discover (Pilot
and Navigator) the module. Refresh and Discovery are the processes by
which your CCS software finds, and then connects to your module.
Refreshing Your Module Using
+
Pilot Lite
When using
+
Pilot Lite to change your module's control parameters,
you must “refresh” the control connection between your 6800
+
frame
and PC. To refresh the connection, from the
+
Pilot Lite menu bar,
select
File
>
Refresh
. For information about controlling a device using
+
Pilot Lite, see your
+
Pilot Lite User Manual.
Discovering Your Module Using CCS Software
To discover your DA-DHR/DH/DSR/DS/HR/H6802
+
modules, your
Pilot or Navigator software must be in Build mode. Follow these steps:
1. If the Discovery window is not open, click
Tools > Discovery
in
the main menu.
A
Discovery
window opens, most likely in the bottom left corner of
the screen.
2. Click
Options
, and then click
Add
.
3. Enter the IP address of the frame that contains your module, the
frame that contains your ICE6800
+
module, or the frame that
contains a 6800
+
ETH module that provides access to your module.
4. Click
OK
to close the
Add IP address
window, and then
OK
again
to close the
Discovery Options
window.
5. Click
Start
.
This triggers Pilot or Navigator to run a discovery.
6. When your discovery is complete,
Discovery Completed
is
displayed in the
Discovery
window. To continue, click
Save
. The
objects you have discovered are saved to the
Discovery
folder of
the
Navigation
pane.