14
DA-DHR/DH/DSR/DS/HR/H6802
+
Installation and Operation Manual
Preliminary—Contents are proprietary and confidential. Do not photocopy or distribute.
Chapter 2: Installation
Setting Jumpers
You need to configure modules for local or remote operation
before
power-up. To change the configuration, first remove power from the
module, reset the jumper, and then reapply power.
Setting J1/J2 Jumpers
The J1 and J2
1
jumpers are used to select local control reclock setting.
Set the J1 jumper for input 1 rate control. Set the J2 jumper for input 2
rate control. Follow this procedure to set the jumpers:
1. Locate the J1 and J2 jumper sets on the module.
shows
the standard location of the jumper sets.
2. Place a shunt on the pin that corresponds to the mode that you want.
(See
for a description of the J1/J2 settings.)
Figure 2-1.
J1
/
J2 Jumper Set Locations
1
Jumper J2 is not operational in DA-HR6802
+
or DA-H6802
+
modules.