Imagine communications Selenio 6800 SFS6803+OP+SFS+, Installation And Operation Manual

Page: 62 / 118

Chapter 3
Operation
48
If your module has an optional laser transmitter component (OP
+
SFS
+
(C)xxD), the Laser
Wavelength parameter displays the wavelength. If the module does not have an optical
component, the Laser Wavelength parameter displays Not Installed .
In addition, OP
+
SFS
+
(C)xxD has one additional alarm that standard SFS6803
+
modules do
not. This alarm is Laser Failed .
Discovering Your Module Using CCS Software
To discover your module, your Navigator software must be in Build mode.
1 If the Discovery window is not open, click Tools > Discovery in the main menu.
A Discovery window opens, most likely in the bottom left corner of the screen.
2 Click Options , and then click Add .
3 Enter the IP address of the frame that contains your module, the frame that contains your
ICE6800
+
module, or the frame that contains a 6800
+
ETH module that provides access to
your module.
4 Click OK to close the Add Host dialog box, and then OK again to close the Discovery
Options dialog box.
5 Click Start .
This triggers Navigator to run a discovery.
When the discovery finishes, Discovery Completed is displayed in the Discovery
pane.
6 Click Save to save the results of your discovery to the Discovery folder of the Navigation
pane.
7 Switch to Control mode by selecting Operational Mode > Control from the main menu.
8 Double-click SFS6803
+
in the Navigation pane.
The Control window opens displaying the module’s controls.
You can now switch to Control mode by selecting Operational Mode > Control from the
main menu. Double-click SFS6803
+
in the Navigation pane (OP
+
SFS
+
modules are referred
to as SFS6803
+
in the Navigator pane). The Control dialog box opens displaying the
module’s controls.
Setting SFS6803
+
and OP
+
SFS
+
Remote Control Parameters
Table 3-12 lists all of the remote control parameters and options for the SFS6803
+
. To
access these parameters, you can use CCS Navigator, an HTTP web browser, or a third-party
SNMP-based control application (depending on your host frame’s options). See your
software user manual for more information.
Note that rows in the table that contain a range of numbers in parentheses indicate that a
series of numbered parameters contain that same function and range.
Legend
Bold option=Indicates that this is the default setting for the parameter.
Rows of the table that are in grey are read-only parameters.