IMAGENEX DT101Xi, Technical Manual

Page: 60 / 64

Doc no: 430-041-01 60 of 64
APPENDIX D
WINDOWS
™ TCP/IP SET-UP AND TROUBLESHOOTING
The SIR unit communicates with the DT101_SIR software running on an attached PC. The connection to the SIR
unit is made via Ethernet and uses the TCP/IP protocol. In order for connection to occur, the TCP/IP parameters
need to be set-up in Windows
™. The following pages detail the set-up process:
Ethernet set-up
The PC should be set to the following addresses:
IP Address 192.168.0.X
Subnet Mask 255.255.255.0
Where
‘X’ is a decimal number between 3 and 254. (The number ‘1’ is reserved for a network server, ‘2’ is
reserved for the DT101
Xi
or DT102
Xi
sonar head, 10 is reserved for the SIR box, and 255 is reserved for
broadcasting).
The DT100 sonar head has a statically assigned IP Address of
192.168.0.2 . This is the number to enter in the
Setup > IP Address menu of the DT100_SIR program, and should not be changed.
The recommended PC IP Address and Subnet mask is as follows:
IP Address 192.168.0.3
Subnet Mask 255.255.255.0
This is done as follows (Windows
™ 10):
•
Navigate to the Control Panel and
double click ‘Network and Sharing Centre’
•
Click ‘Change adapter settings’
•
Right click on the Ethernet interface you wish to connect with and select ‘Properties’
•
Select ‘Internet Protocol Version 4 (TCP/IPv4)’
•
Click Properties
•
Configure as follows and click OK: