MDtest (100-140 V) - User’s Manual
5
Database operations
The ID number should be entered before the start of the measurement.
If the ID number already exists in the main memory (e.g. was trans-
ferred from a PC), then the data is loaded into temporary memory. If
the user forgot to enter the ID number before the start of the mea-
surement, it is possible to enter it before saving the data file into the
main memory of the appliance. However, if the appliance with this ID
exists already, the data will be rewritten completely!
Barcode scanner, external keyboard
Any device which has an USB 2.0 Full Speed HID (Human Interface Device) can be
used with MDtest.
•
Plug the barcode scanner or keyboard into the USB connector
8
.
•
A confirmation beep confirms the barcode has been received. If an external
keyboard is used, press the ENTER key to confirm the ID and the ID number
will be displayed.
•
The ID number is read only when measurement is not in progress and/or no
menu / warning is displayed.
The ID number can be inserted via barcode scanner or keyboard in
the ID editor mode too.
5.5
Working with test results
5.5.1
Viewing a list of tested DUTs
Use the
[
N
]
or
[
H
]
keys to display a list of tested DUTs, which are stored in the
main memory. The data stored for each appliance can be viewed or edited. To
modify/edit stored data, it is necessary to transfer the data to temporary memory
and after modification send the data back to the main memory.
The list of appliances contains the following information:
•
ID number
•
measured values - if the device has been loaded onto the temporary memory
and then stored in the main memory the symbol
(V) – value
is displayed
•
test sequence – if a test sequence is made for the device, the symbol
(S) –
sequence
is displayed
The symbol
(V)
next the ID of DUT is displayed even if no measure-
ment has been performed. The symbol only informs the user about a
data transfer from temporary memory to the main memory.
c
2018 ILLKO, s.r.o.
www.illko.cz
Page 47
