_____________________________________________________________________________________________________________________________________________________________
NetDVR User Manual
21 / 97
•
Insert a pair of AAA 1.5V battery. Please take care that the poles (+ and -) are correctly positioned.
•
Replace the battery cover.
Start to use IR controller
IR controller is designed to control multiple NetDVR devices. It recognizes the target NetDVR by device ID.
Press [DEV] key, input the NetDVR device ID (default is “255”, it can be changed in “Display” menu) and then press [ENTER] key. If the “STATUS” lamp of NetDVR
front panel is turned into green, it means you can use IR controller to operate this NetDVR.
Stop using IR controller
When IR controller status is on, press [DEV] key again, the “STATUS” lamp will be turned off. The IR controller cannot control this NetDVR.
Turn off the NetDVR
When IR controller status is on, press [POWER] key for several seconds, the NetDVR will be turned off.
When IR controller cannot work normally
•
Check IR Receiver if it is masked
•
Check IR Controller’s sensor if it is masked
•
Replace new batteries
•
It the problem still exists, please change another IR Controller to try again or contact your dealer for repair.
3.3
Using USB Mouse
A regular 3-button (Left/Right/Scroll-wheel) USB mouse can also be used with this DVR. To use a USB mouse:
1)
Plug USB mouse into one of the USB ports on the front panel of the DVR.
2)
The mouse should automatically be detected. If in a rare case that the mouse is not detected, please refer to the recommended device list from your provider.
The buttons on the mouse corresponds to:
1)
Left Button:
•
Single-Click:
Select a component of a menu, such as a button or an input field. This is similar to pressing the ENTER button on the remote/front panel controls.
•
Double-Click:
Switch between single screen and multi-screen mode in Preview/ Playback mode.
•
Click and Drag:
Clicking and dragging the Left mouse button can be used to control the pan/tilt of a PTZ camera as well as to vary the position of digital zoom area
and camera OSD. It can also be used to setup the alarm areas.
2)
Right Button:
