PK3561_10_09 • 79 SERIES INSTALLATION GUIDE
34
6. Put the thumbturn (T) in a vertical position as shown below.
Assemble 3 spacers (S) on the door (for recent models only).
For 79T Toggle mode connect (W2) to (W1) and
push both
connectors and all excess of wire in hole (H1)
. Place the
inside trim assembly on the door so that the upper and lower
spindles (F) and (G) engage the thumbturn and the inside lever.
Fasten to the outside housing using the three 1/8" hex drive
mounting screws (I). Install the screws without tightening.
Verify the inside lever and thumbturn operates smootly. If not
move the inside and outside housings slightly. Then tighten
the screws.
7. Three AA batteries should already be installed in the battery
holder (C). Insert the battery holder into the outside housing
and secure it using the 6-32 x 5/16" (7.9mm) Torx drive
screw (H).
C
8. Testing the cylindrical lock: Follow all steps of page 12 or 13
but extension and retraction will be for latch only.
If the lock makes a continuous buzzing noise or the red
LED lights continuously, reset the electronics by removing
the battery holder for ten seconds, then reinsert it.
!
W1
W2
E or E2
H1