12
Gently pull backward
on the Mounting Tray
Tab to remove
Removing the Camera from the Housing
1. Thoroughly dry housing.
2. Remove the housing back, see Step 2, Opening the Housing, Page 8.
3. Pull on the Thumb Screw with your index finger. Slowly and gently pull the
camera backward to separate from housing, Diagram D. Continue pulling
the camera backward and remove from housing. We recommend doing this
procedure on a desktop or solid flat surface to avoid dropping the camera.
If you are finished using the housing, remove the Mounting Tray from the
camera bottom and slide it back into the Housing Mounting Plate. For
storage and travel, remove the back o-ring and place in a small plastic bag.
Place the bag inside the housing and reattach the housing back.
Note:
The camera MUST be removed from the housing when changing a
camera battery or SD card.
Diagram D
Thumb Screw
Before entering the water, turn the camera ON and operate each of the
housing controls to get a feel for using the camera in the housing.
As soon as you enter the water, take a moment and check to see that the
housing is properly sealed. Using your finger, wipe away any air bubbles
on the face of the lens port. If possible, first water test the housing with no
camera inside to assure a safe and watertight environment.
Step 6 - Entering the Water
