Ikegami ICD 525, Instruction Manual

Page: 10 / 32

5
①
Lens Mount (CS Mount)
Lens fi xing Mount for various CS Mount lens (C-mount adaptor can be
attached).
② Fixing screw for Lens fl ange back focus adjustment
Loose the screw before fl ange back focus adjustment, and tight after
this adjustment.
③ Flange back focus adjustment mechanism
If it is unfocused picture even after adjust the focus ring of lens, fl ange
back focus adjustment shall be done (adjust the depth between lens
fi xing surface and CCD image capture face).
④ The screw holes for camera holder/mount
These screw holes are for fi xing the camera holder for wall or ceiling,
also tripod for photo camera.
The fi xing screw length for camera holder and tripod should be less
than 5.5mm as follows (1/4”-20UNC) size screw.
⑤
Video Output connector (Video out)
Video signal out connector for monitor/switcher.
⑥
Power Input connector (non polarity)
Enter the power of AC24V IN (±10%)/DC12V (DC10.5V to 15V).
⑦ Power indicator
LED: It is lit green when power on.
⑧ Auto iris lens connector (for DC control iris lens only)
This connector is used for connecting DC Iris control cable plug
(Applicable E4-191J-100 or equivalent) for DC type auto iris lens.
●
DC Iris System
— Connector cable leads —
1. Damping coil (-)
2. Damping coil (+)
3. Driving coil (+)
4. Driving coil (-)
* Connect the leads as shown above.
Please refer also to the instruction manual
of lens to be used.
⑨ to ⑩ Button for Set up
See page 7 “Operation”.
3
2
1
4
Auto iris lens
3
2
1
4
Connector pin assignment