36
042009
☞
Feed the steam pipe in until it stops.
☞
Then lock the locking device by turning it clockwise by 60°
(fig. 10).
☞
Check the axial locking device on the steam pipe.
Push-off mechanism
The plastic screw nut (H) helps loosen tight-fitting piston ground-in
connections (Fig. 9).
☞
Hold the locking device and loosen the plastic screw nut (H).
☞
To do so, hold the tight-fitting evaporator piston and turn the pla-
stic screw nut (H) until the evaporator piston neck.
Before using the device, hand-tighten the plastic screw nut (H)
against the left-hand stop. This will hold the steam pipe locking de-
vice (G) firmly in place.
Fitting the condenser seal
☞
Place the RV 06.15 or RV 06.13 condenser seal in the condenser
receptacle and fit the glassware to the device according to the as-
sembly instructions (Fig. 11 a,b, c and d).
Fig. 10
Fig. 11b
Fig. 11a
First use - Fitting the seal RV 06.15/RV 06.13
☞
Insert vapour tube (1).
☞
Insert seal RV 06.15 (2).
☞
Slide the union nut (3b) over the flange on the condenser (3a).
☞
Also slide the annular spring (3c) over the flange on the condenser (3a).
☞
Position the condenser (3a) on top of the seal (2).
☞
Tighten the union nut (3b) by hand onto the threaded flange. Run the
device for 20 minutes at 120 rpm. Finally, retighten the union nut (3b) by
hand.
Note: Follow the mounting instructions for the glassware
Assembling the vertical glassware cooler locking device
☞
Assemble the condenser locking device according to the diagram
(fig. 12).
☞
Mount the plate (I) using the thumb screw (J).
☞
Put the support rod (L) on the plate (I) and attach it with the screw
nut (K).
☞
Attach the rubber protector (M).
☞
Fasten the Velcro band (N) to the support rod (L).
☞
Secure the vertical glassware with the Velcro band (N).
1
2
3
a
3
b
Fig. 11c
Fig. 12
J
I
L
K
N
M
H
Fig. 11d
3c
