44
042009
Functional description (in as-delivered state)
Factory settings
The values specified below correspond to the as-delivered state (dis-
play output/factory language setting is English).
The start-up screen will be displayed for few seconds. This shows
the software and hardware versions for the device.
The main menu will appear after a few seconds
☞
Turn the rotary/push knob to the right/left to select a menu option.
☞
Confirm the selection by pressing the rotary/push knob.
“Settings“ menu
The following options are available from the "Settings" menu.
☞
Turn the rotary/push knob to the right/left to select a menu option.
☞
Confirm the selection by pressing the rotary/push knob.
Basic guide to using the menu system
Selecting a menu
☞
Turn the rotary/push knob to the right/left to select the desired
menu option.
Note: The active menu item is shown with a black background on
the display.
Editing values
☞
Press the rotary/push knob
☞
Turn the rotary/push knob to change the value (the magnitude of
the change is dependent on the speed at which the knob is tur-
ned).
☞
Press the rotary/push knob again to complete the process.
Exiting a menu
☞
Press the SET button.
Current values are stored.
Next-highest menu level is displayed.
☞
Press the ESC button.
Current values are not stored.
Next-highest menu level is displayed.
Note: Some menu items do not contain values that can be stored.
Select SET or ESC to exit the menu.
Note: Certain menu items have functionality that varies from or adds
to that described above.
Display screen during the distillation process
Each operating mode has its own dedicated display screen. The fol-
lowing display characteristics are common:
- When a distillation is in progress it is not possible to leave the ac-
tive display indicated.
- Press SET or ESC to exit the active display mode when no distilla-
tion is in progress. This will return the display to the main menu.
Error messages
☞
Press ESC to acknowledge the fault if an error message appears
on the display.
The error message will disappear.
Note: In the case of serious faults, an additional display message
will appear indicating that the device must be switched off and only
switched back on again when the fault has been rectified.
The unit is ready for service when the
mains plug has been plugged in.
Switching on the device
☞
Switch on the device on the right side of the device by the mains
plug (fig.25).
☞
Device functions activated.
Note: The heating bath must also be switched on.
Commissioning
Fig.25
