Ignition Co9Z LED Flood IP65 540W RGBW, User Manual

Page: 37 / 44

10 Troubleshooting
In the following we list a few common problems that may occur during operation.
We give you some suggestions for easy troubleshooting:
Symptom Remedy
The unit does not work, no light Check the mains connection and main fuse.
One of the colours does not work or the colours
differ when using several lamps.
Check the settings in the “White Balance” menu. Values may be set to ‘000’
when no function is available.
If the rendering of colours differs, set all colour values in the
‘White Balance’
menu to ‘255’ . You can then fine tune the colour rendering.
No response to the DMX controller 1. Check the DMX connectors and cables for proper connection
2. Try using another DMX controller.
3. Check whether the DMX cables run near or parallel to high-voltage cables
that may cause damage or interference to a DMX interface circuit.
4. Press Mode until the display shows ‘ADDRESS XXX’ .
5. Check wether ‘DMX’ (for wired connection) is selected in the ‘DMX Signal
Select’ menu.
The devices do not link to the WDMX trans‐
mitter or do not respond to the W-DMX signal.
Check wether ‘Wireless DMX’ is selected in the ‘DMX Signal Select’ menu. Reset
the connection by running a reset via the ‘Reset Wireless DMX Memory’ menu.
The fixtures must then be reassigned to the transmitter by pressing [Link] on
the transmitter.
The device does not respond to the W-DMX
signal or responds with delay.
Check the transmission mode of the W-DMX transmitter. Test the connection
in G5, G4S or G3 mode (if possible). Note that the W-DMX of all units must be
reset after changing the transmitter.
If the procedures recommended above do not succeed, please contact our Service
Center. You can find the contact information at www.thomann.de .
Troubleshooting
Co9Z LED Flood IP65 540W RGBW
37
LED floodlight