EPL-PM-1X30LED-120XLV-100
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
1
of
2
EPL-PM-1X30LED-120XLV-100 Instruction Guide
30W Explosion Proof LED Light
Thank you for your purchase of the Larson Electronics 30W Explosion Proof LED Light. Please follow the
steps below in order to operate and maintain this product.
IMPORTANT
READ CAREFULLY BEFORE OPERATING THIS FIXTURE. SAVE THESE INSTRUCTIONS FOR FUTURE
REFERENCE. THE EPL-PM-1X30LED-120XLV-100 MUST BE OPERATED IN ACCORDANCE WITH NATIONAL
ELECTRICAL CODE AND ALL APPLICABLE LOCAL CODES. PROPER GROUNDING IS REQUIRED FOR SAFETY.
FOR PERSONAL SAFETY, ALWAYS CONFIRM THE RATING OF ANY KNOWN HAZARDOUS OR POTENTIALLY
HAZARDOUS LOCATION WHERE THE LIGHT IS TO BE USED.
WARNING:
ALL WIRING SHOULD BE DONE BY A LICENSED ELECTRICIAN IN ACCORDANCE WITH STATE
CODES, LOCAL CODES AND NATIONAL ELECTRIC CODE (NEC) STANDARDS.
WARNING:
TO PREVENT IGNITION OF A HAZARDOUS ATMOSPHERE, THE SUPPLY CIRCUIT SHOULD BE
DISCONNECTED WHEN INSTALLING OR PERFORMING ANY MAINTENANCE ON THIS UNIT.
WARNING:
DO NOT SCRATCH OR CHIP THE FRONT LENS. TURN THE POWER OFF AND LET UNIT COOL
BEFORE STARTING INSTALLATION OR REPAIR.
WARNING:
OPERATE THIS FIXTURE ONLY AT THE VOLTAGE OF YOUR SPECIFIC SUPPLY CIRCUIT. FAILURE
TO DO SO WILL RESULT IN DAMAGE TO THE FIXTURE.
WARNING:
SUBSTITUTE COMPONENTS MAY IMPAIR EXPLOSION PROOF SAFETY.
•
IMPROPER INSTALLATION MAY RESULT IN SERIOUS INJURY AND VOID WARRANTY.
•
CONTAINS PARTS AND ASSEMBLIES SUSCEPTIBLE TO DAMAGE BY ELECTROSTATIC DISCHARGE (ESD).
•
GROUND FAULT CIRCUIT INTERRUPTER (GFCI) PROTECTION IS TO BE PROVIDED ON THE CIRCUIT(S) OR
OUTLET(S) TO BE USED FOR THE WET LOCATION PORTABLE LUMINAIRE.
•
RECEPTACLES ARE AVAILABLE HAVING BUILT-IN GFCI PROTECTION AND ARE ABLE TO BE USED FOR
THIS MEASURE OF SAFETY.
•
THESE INSTRUCTIONS INCLUDE INFORMATION FOR INSTALLATIONS IN BOTH HAZARDOUS LOCATIONS
AND MARINE LOCATIONS. MANY SECTIONS APPLY TO BOTH APPLICATIONS. THE APPROPRIATE WARNING
AND SPECIAL INSTRUCTIONS SHOULD BE FOLLOWED, DEPENDING ON THE APPLICATION.
OPERATING
This unit comes preconfigured with the selected Voltage and Cord Cap from factory. The unit is factory sealed
and ready for use out of the box.
1.
Position light in desired location near power source.
2.
Plug the inline transformer into compatible outlet providing
VOLTAGE LISTED ON NAMEPLATE
.
3.
This lamp is “instant-on” and will illuminate once power is supplied. DO NOT look directly at LED’s
when powering on.
AIMING
1.
Loosen tightening knob on side of fixture.
2.
Pivot light up or down to desired angle.
3.
Tighten knob to secure position.
4.
(If Applicable) Adjust the rotation of light with tightening bolt near the base.
Use the top handle for maneuvering the unit.
COVER REMOVAL
Rotate lens counter-clockwise to remove. Use a rectangular steel bar as needed. Excessive force must not be
used as bar may slip and cause injury.
Be sure lens cover is secure before use in hazardous areas!
