IGBT MIG-200M, User Manual

Page: 9 / 21

8
5. INSTALLATION
5.1 Power cord connection:
Connect the machine to the 1phase 220V AC Power supply with leakage protection switch.
5.2 Output cables connection:
5.2.1 Under MIG with solid wire: welding cable
connector connects
“
+
” ，
earth clamp connects
“
-
” ，
torch connect to
“ ”
and fasten it.
5.2.2 Under Flux cored welding with flux wire:
welding cable connector connects
“
-
”，
earth clamp
connects
“
+
” ，
torch connect to
“ ”
and fasten
it.
5.2.3 Under MMA mode: welding electrode holder
connects
“
+
” ，
earth clamp connects
“
-
”
.
Notice for spool gun:
When using spool gun, please select the torch switch at “Spool Gun” in the internal panel. Please
choose the spool gun with 24V motor, and it is usually used to weld aluminum or aluminum alloy.
Please use AR 100% as protection gas and welding t
echnics mode set at “SPOOL GUN
ALUMINUM”. Then choose the suitable welding wire size and parameters. For the spool gun
connector on the front panel, “1” “2” is for torch switch, “3””4” is for wire feeder. (“3” is to wire
feeder motor +, and “4” is for wire feeder motor -.)
Figure 1 Figure 2