UK
Process and dialogue module ecomatDisplay CR1074, CR1075, CR1076, CR1077
33
ifm electronic gmbh • Friedrichstraße 1 • 45128 Essen We reserve the right to make technical alterations without prior notice!
17�09�2020
CR1075 / page 2
CR1075
Technical data
Control systems
Protection rating
IP 65 / IP 67 (for inserted connectors with individually sealed cores and inserted
M12 connectors/sealing caps)
Ambient temperature
-35...65° C (up to 2000 m above sea level)
-35...60° C (up to 3000 m above sea level)
Storage temperature
-35���85° C
Max� perm� relative humidity
90 % (not condensing)
Height above sea level
max� 3000 m
Pollution degree
2 (before installation and when the device is replaced)
Weight
approx� 1�3 kg
Electrical data
Operating voltage
8...16 V DC or 16...32 V DC
Reverse polarity protection
yes, in case of supply via the on-board system (battery)
Power consumption VBB
30
27 W
Current consumption VBB
0
5 A
Processor
ARM dual core, 64 bits, 800 MHz with GPU
Memory (total)
1 GByte RAM / 4 GBytes fl ash, non-volatile memory: 16 kB
Interfaces
CAN0���3
CAN interface 2�0 A/B, ISO 11898
20 Kbits/s...1 Mbit/s (default 250 Kbits/s)
CANopen, CiA DS 301 version 4�2, CiA DS 401 version 1�4
or SAE J1939 or free protocol (Raw CAN)
ETH0
transmission rate 10/100 Mbits/s
protocols: TCP/IP, UDP, Modbus TCP, OPC UA Micro Embedded Device Server,
EtherNet/IP scanner / adapter
USB0
USB 2�0 high speed, transmission rate up to 480 Mbits/s
USB master operation
output current per interface ≤ 500 mA
Analogue video input 0���1
FBAS inputs, 1 Vss, 75 Ω (inputs selectable)
supported video standards: PAL and NTSC
cable length:
≤ 30 m
Input 0���1
digital B
L
binary low side (CSI)
Output 0���1
digital B
H
binary high side (CSO) supply via VBB
0
IFM0���1
connection external operating units
Characteristics of the digital inputs
Input resistance
10 kΩ
Input frequency
< 20 Hz
Switch-on level
> 0.7 VBB
30
Switch-off level
< 0.3 VBB
30
Characteristics of the digital outputs
Diagnostics status feedback at level
> 2 V with 200 mV hysteresis detection
of short circuit to VBB as well as short
circuit to GND
Switching voltage
8...32 V DC
Switching current
0�025���2�5 A
Output frequency
< 20 Hz
Protective circuit for inductive
loads
integrated
Software/programming
Operating system
Embedded Linux 4�14
Programming system
CODESYS 3.5 (IEC 61131-3)
Graphic functions
via integrated target visualisation
