edgeController
39
>
Enabling / disabling password protection
61325
On delivery, the password protection for the setup menu is disabled.
If the password protection is enabled after the first setup, the password set at the factory will
be valid:
pdm3
► To ensure effective protection, change this password set at the factory!
The programming software CODESYS can access the IEC project saved on the device even if
password protection is enabled.
Requirements:
•
The menu page [System Setup] is active.
► [Password]
>
The menu page shows the available options.
► Enable [Enable Password] to activate password protection.
OR
► Disable [Enable Password] to deactivate password protection.
>
The last valid password is requested.
► Enter the correct password.
► Optional: Click on
to show and check the entered password.
► Click on
to confirm the input.
>
Password protection is enabled / disabled.
>
The screen shows a status message.
The password protection will be active the next time the setup menu is opened.
► Change to the set-up start page.
► Click on
to leave the set-up.
>
The start screen of the set-up mode appears.
► Click on [Launch Setup] to start the set-up.
>
Password protection is effective.
