IFM AC1433, Device Manual

Page: 105 / 168

SmartPLC DataLine with EtherCAT slave interface
105
6.4 Connect and address AS-i slaves
41575
To integrate AS-i slaves into an AS-i network that is controlled by one of the AS-i masters of the
device:
1 Connect and address the AS-i slave
► Connect ONE AS-i slave to be addressed to the requested AS-i network (AS-i 1 or AS-i 2) as described in the
corresponding installation instructions.
► Assign the desired address to the AS-i slave
(→
Quick setup: Address the AS-i slaves connected to AS-i Master 1 (→ S. 46 ) or → Quick setup: Address
the AS-i slaves connected to AS-i Master 2 (→ S. 47 )).
► Optional: Repeat step 1 to connect and address further AS-i slaves.
2 Project the AS-i network
►
Carry out a projection adaptation on the AS-i master with the newly addressed AS-i slaves
(→
Quick setup: Project AS-i networks (→ S. 39 )).
> The AS-i master adds the detected slaves (LDS) to the list of the projected slaves (LPS).
> The AS-i slaves have a valid address and are integrated in the AS-i network.
>
6.5 Configure EtherCAT interface
42165
If AC1433/34 is to be operated as EtherCAT slave:
► Set device ID (→ Configure the EtherCAT interface (→ S. 90 ))
► In the EtherCAT projection software:
1. Integrate the AC1433/34 into the EtherCAT project.
2. Optional: AC1433/34 is added to a hot-connect group.
3. Configure EtherCAT slots of the AC1433/34 (→
Cyclic data (→ S. 138 )).
If the AC1433/34 is to be operated as EtherCAT master:
► Add and configure EtherCAT master stack (→ Programming manual)
>
6.6 Set Ethernet configuration interfaces
42937
To configure the Ethernet configuration interfaces 1 (X3) and 2 (X8):

Ethernet configuration interface 1 (X3):
► >
► Select [IP setup].
►
Set interface parameters (→ Notes on IP settings (→ S. 83 )).

Ethernet configuration interface 2 (X8):
►
>
► Select [IP setup].
► Set interface parameters (→ Notes on IP settings (→ S. 83 )).
>
6.7 Exchange AS-i slave
41506