IEMCA MASTER 880-VERSO P, Manual For Use And Maintenance

Page: 131 / 232

6 - USE AND OPERATION MASTER 880/880r VERSO
EN
6 - Pag. 11 / 23
6.5 BAR FEEDER TOOLING
This is a list of all the bar feeder tooling phases, assuming that the bar feeder is started for the
first time.
• Perform the bar feeder setup according to the bar to be machined.
• Prepare the bar to be machined.
• Load the bar magazine.
• Start the automatic cycle.
• Adjust the lubricating oil flow.
6.6 BARS TO BE MACHINED - FEATURES AND PREPARATION
WARNING — CAUTION:
do not insert bars having different sizes than the ones set by the manufacturer.
Refer to the "VERSION DESCRIPTION" paragraph in section 2 for the maximum
bar length.
INFORMATION:
With the bundle magazine the bars of the minimum allowed length (see §
"TECHNICAL DATA") are to be loaded at the centre of the magazine
INFORMATION:
the bar must not have a straightness defect above 0.5 per 1,000.
Please find hereafter some advices to optimise the bar feeder performances.
Usually it is not necessary to perform preliminary operations on the bar ends, but to obtain
optimum results during loading, it is advisable to chamfer them.