IEI Technology A200C-800Z-R10, User Manual, Page: 81 / 177

1 -81
A200C-800Z-R10 Motherboard
81
4.3.2 Components to Install
To install the A200, the following components must be installed or connected to the A200
DIMM modules
Peripheral devices
4.3.3 DIMM Module Installation
4.3.3.1 Purchasing the Memory Module
When you purchase your DIMM modules, the following considerations should be taken
into account:
Each DIMM module can support a memory chip with a maximum size of 1GB
Each DIMM module can have a maximum speed of 333MHz
It is recommended that you use memory modules of identical brand, size,
chips, and speed.
DIMMs must use the same density memory chips
Both DIMMs must use the same DRAM bus width
Both DIMMs must be either single-sided or dual-sided.
4.3.3.2 DIMM Module Installation
The A200 motherboard has two DDR SDRAM DIMM sockets. To install the DIMM
modules, follow the instructions below.
Step 1: Pull the two white handles on either side of the DIMM socket down.
Step 2: Align the DIMM module with the DIMM socket making sure the matching pins
are correctly aligned.
Step 3: Insert the DIMM module slowly. Once you are sure it is correctly inserted, push
down firmly. The white handles on either side of the socket will move back up
and lock the module into the socket. Step 0:
4.3.4 Peripheral Device Connection
Cables provided by IEI that connect peripheral devices to the board are listed in Table 4-1 .
Cables not included in the kit must be separately purchased.