IDX Zolar Z440, Installation & Operation Instructions

Page: 8 / 9

8
Zolar
Configuration
Examples
Ex. Weep #1 Output Aux. #1 Output Sensor #1 Sensor #2 Notes:
1 Single-Temp Weep ---- Temperature ---- Configure Aux #1 for control by Temperature.
2 Single-Temp Weep Slab Heat Temperature Temperature Configure Aux #1 for control by Temperature.
3 Single-Temp Weep Exterior Lights Temperature Light Configure Aux #1 for control by Light.
4 Single-Temp Weep Equipment-Timed Temperature ----- ( Time ) Configure Aux #1 for control by Time.
5 Dual-Temp Weep ---- Temperature Temperature Configure Aux #1 for control by Time. (2)
6 Dual-Temp Weep Equipment-Timed Temperature Temp (Time) Configure Aux #1 for control by Time. (2)
8 ----- Slab Heat ----- Temperature Configure Aux #1 for control by Temperature.
9 ----- Exterior Lights ----- Light Configure Aux #1 for control by Light.
10 ----- Equipment-Timed ----- ----- ( Time ) Configure Aux #1 for control by Time.
Notes:
1. When the Expanded Output Option is installed, its respective outputs and sensors (Weep #2, Aux #2, Sensor #3, and Sensor #4 ) are configured
and behave identically as the corresponding outputs and sensors in the table above.
2. Zolar detects the Dual-Temp Weep configuration automatically when you install two Temperature Probes, but configure Aux #1 for control by Time
rather than by the attached sensor. Zolar then automatically assigns the purpose of the second Temperature Probe to that of Dual-Temp Weep.
3. Zolar automatically detects the presence or absence of a Temperature Probe. When a Temperature Probe is not installed for Sensor #1 or for
Sensor #2 (when configured for temperature) Zolar will disable the function of the corresponding Output so that it remains in the Off state.
Zolar Factory Default
Configuration
The following table specifies the Menu Configuration values when Zolar is shipped from the factory unless other choices are specifically requested. Additionally,
should there be a replacement of, or failure of, the EEPROM chip that holds these values, Zolar will automatically re-initialize the EEPROM to these values.
Temperature Format °F Auxiliary Temperature 34°F On Lo Weep Alarm Low 0°F
Weep Start Temperature 34°F Auxiliary Light Level 0.7% Auxiliary Alarm Low 30°F
Weep Full On Temperature 15°F Auxiliary Time On 6:00 AM Auxiliary Alarm High 120°F
Foam Blower Temperature 34°F Auxiliary Time Off 6:00 PM Days Warm, Days Powered 0