Idromatic PULSE Series, Instruction Manual

Page: 24 / 36

24
Use only liquid detergent. Do not use abslolutely acid
product or very alcaline.
Functioning with mains water supply (MOD.B)
➢
Remove front cover and turn the 3 way selector to the
position shown in Fig.4
➢
Connect supply water hose to the inlet.(Fig..5)
➢
Open the water supply
Starting the appliance
Make sure the electric supply has the electric
specifications of the machine (Voltage-Power –
Amps). Read technical data.
.
The appliance may only be connected to an electrical supply
which has been installed by an electrician in accordance with
IEC 60364-1.
➢
Make sure the switches on control panel are OFF position
before plug the machine
.
➢
Make sure the steam regulation knob is open and the boiler
blow down valve closed (Fig.10)
➢
Plug the machine
The indicator light turns on meaning the appliance
is correctly plugged in and ready for use.
➢
Open the steam solenoid valve pushing the button on
control panel (Fig.3). The green light of the button will turn
on.
➢
Rotate the main switch from OFF to ON.
The appliance will start filling the boiler with water and during
this time the alarm light will be ON with continuous beep. Then
when the water reaches the correct level detected by the water
probe sensor in the boiler the appliance will start heating.
During the first filling of the boiler Keep trigger gun
open while water pump is running and for the first few
minutes of heating. This operation discharges the air and
condensate inside boiler and hose.
The boiler takes about 5 minutes to produce the first steam.
Normal use
Warning: hot steam. Burn hazard
Duringe normal use some fittings or accessories
become very hot. Use protective gloves
Use protective goggles
Always follow safety indications regarding use of the
machine.
➢
Keep the trigger open to clean with dry steam
Use optional accessories to make specific and more
effective cleaning of the surfaces or parts to be
cleaned
➢
In case of stopping the operations enable the safety lever
on the gun. (FIG. 9)
➢
During normal use if the light goes ON the machine
stops working and it is necessary to refill with water the
tank.
➢
During the normal use if the light goes ON the
detergent injection stops working and it is necessary to
refill the detergent tank.
Use with detergent or water injection
➢
Select WATER or CHEMICAL rotating the lever of the 3
way valve on the outlet panel.
➢
Push the button switch ON and open the trigger gun to
activate the detergent/water injection (FIG.9)
The additional pump for detergent-water injection
is able to run only if there’s liquid inside the
detergent tank.
Shutting down and storage
➢
When work is finished turn off the machine and
discharge the steam with trigger gun
➢
After finishing pressure discharge the boiler unplug the
machine and store in a safety place.
Frost Protection: If the machine is stored in areas with
temperatures 0° C / 32 F make sure to discharge the
boiler with the blow down valve and to discharge also water
tank and filters. Frost can cause damages to the appliance
and to its components. Discharge water tank dismount the
tap with hand (Fig.14)