Part 2 - Configuration
69
on the remote control or right-click on the mouse to
open up the Zone Setup menu.
–
Select
: Confirm the block selection in the selection
window.
–
Clear
: Clear the block selection in the selection
window.
–
Reverse
: Clear the blocks selected within the
selection window and select all unselected blocks
within the selection window.
–
Select All
: Select all blocks.
–
Clear All
: Clear all block selections.
–
Reverse All
: Clear all selected blocks within the
screen and select all unselected blocks within the
screen.
–
OK
: Save the changes and exit the menu.
–
Cancel
: Exit the menu without saving the changes.
●
Setup
–
Sensitivity
: Set daytime and nighttime sensitivity
settings between 1 (Low) and 5 (High).
–
Min. Blocks
: Motion needs to be detected in more
than the specified number of blocks in order to
trigger a Motion Detection event. You may select a
value between 1 and the number of blocks selected
under
Zone
for daytime and nighttime, each.
–
Ignoring Interval
: The system does not produce
event log entries or remote notifications for motion
detected within a certain period of time after the
motion of the camera channels is detected. Set the
value between 1 sec and 5 secs or choose
Never
.
Ignoring Interval does not affect motion detection
recording.
–
Daytime Setup
: Specify when daytime starts
and ends. Adjust the time frame in 15-minute
increments. Times outside the specified range will
be assumed as nighttime by the system.
–
Detecting motion in PTZ movement
: It can be set
to detect events during PTZ operation.
●
Condition
: When a specific event occurs, you can set
the condition that determines whether to operate
motion according to the status of other events.
–
Reference Only
: Set the event to be the subject of
a reference.
–
Event
: Set the reference event.
–
Channel
: Set the reference channel.
●
Actions
: Specify which actions to take when motion
is detected.
–
Record
: Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to Event or Time & Event mode, the selected
cameras will begin linked recording when an event
occurs.
–
Alarm-Out
: Designate event-triggered alarm-out
channels (each for the NVR and camera) and beeps.
–
Notify
: Configure to be notified of events by Mail,
LAN1 through 5, Push, HTTP, FTP, and/or Alert
Window.
–
PTZ
: Moves the PTZ camera to a specific preset
position when an event occurs.
–
Event Monitoring:
Selects the cameras to monitor
when an event occurs.
In order to use the Callback feature, the NVR must be
registered on the remote program.
