Part 1 – Introduction
11
3
Alarm I/O
DC-B1103 / DC-B1203 only
•
Out
: Connect an alarm out device's mechanical
or electrical switch to the alarm out port and
the GND (ground) connector. (Supported Types:
Active Low (open collector output), Electrical
Specs: 30mA sync current at 5 VDC)
•
In
: Connect an alarm-in device to this port.
(Mechanism: Choose between an NC (Normally
Closed) type or an NO (Normally Open) type)
Connect a mechanical or electrical switch to the
alarm in port and the GND (ground) connector.
Alarm in range is 0V to 5V. In order to detect
alarm input from an electrical switch, the signal
must be higher than 4.3V from an NC switch or
less than 0.3V from an NO switch and must last
for longer than 0.5 seconds.
4
Factory Reset Switch
Restores the camera's default factory settings. For
more information, refer to the
Factory Reset
.
When inserting an , audio in/out, or RS485
connector, hold down the button and push the
connector in through the exposed hole. ( and audio
in/out apply to
DC-B1103 / DC-B1203
models only)
Release the button and then gently pull on the wire
to ensure a secure connection. To disconnect the
cable, press down on the button again and pull the
cable out.
•
Check your local laws and regulations on making
video or audio recordings. The user will be held
liable for any violation of the law. (Article 25-5 of
the Personal Information Protection Act: Operators
of image data processing devices may not
operate such devices for purposes other than as
originally intended during device installation, place
such devices at locations other than as originally
intended, or use such devices to record audio.)
•
The network connector is not designed to be
connected directly with cable or wire intended for
outdoor use.
Factory Reset
Only use the factory reset switch to restore the
camera to its factory default settings.
A factory reset will clear all camera settings
configured by the user.
1
Shut off the power supply, insert a straight pin
into the switch hole, and press down on the reset
switch.
2
Hold the switch down and reconnect the power
adapter.
3
Once the device turns back on and its LEDs start
blinking, wait 5 seconds and then remove the pin.
4
The device will go through the resetting process
and reboot. All camera settings will be restored to
their factory defaults after the reboot.
It's also possible to do a factory reset by pressing and
releasing the reset switch while the camera is turned
on or using the IDIS Discovery program from a remote
location. A factory reset will reboot the system. For
more information on factory reset, refer to the
IDIS
Discovery operation manual
.
